Skip to main content

Concrete Stain & Epoxy in Gulf Stream, FL

Ground, repaired and sealed concrete coatings for garages, patios, pool decks and commercial floors that resist stains, wear and moisture.

Concrete Stain & Epoxy for Gulf Stream Homes

Patios, loggias and pool decks are where many Gulf Stream homeowners spend their time outdoors, and stained or faded concrete stands out against well kept landscaping. A penetrating stain or a decorative coating can give these areas a consistent, finished color that suits the house and holds up to sun and pool water.

In garages, an epoxy or polyaspartic system makes the floor easy to clean and resistant to oil and tire marks. We diamond grind for a proper bond, repair cracks, and apply a UV stable topcoat where sunlight reaches the floor through an open door. Most garages are done in one to two days.

What's Included

  • Moisture testing and inspection of the slab
  • Diamond grinding to remove contaminants and profile the surface
  • Crack, joint and divot repair
  • Epoxy or polyaspartic base coat
  • Chip flake broadcast, metallic or solid color finish
  • Acid stain finishes for a natural stone look
  • UV-stable, chemical-resistant topcoat
  • Non-slip additive for areas that get wet

Want the full picture? Read our complete concrete stain & epoxy guide or see everything we do in Gulf Stream.

How We Prepare and Apply

  1. 1

    Assess the slab

    We check for cracks, old coatings, oil saturation and moisture, which tells us which system and primer the floor needs.

  2. 2

    Clear and degrease

    The area is emptied, swept and degreased so grinding does not push oil and dirt deeper into the surface.

  3. 3

    Diamond grind

    Industrial grinders profile the concrete and strip sealers and contaminants, with dust collection keeping the work area cleaner.

  4. 4

    Repair defects

    Cracks, spalls and divots are filled and ground flush so the finished floor is level and uniform.

  5. 5

    Apply base and topcoat

    The base coat goes down, with flakes or metallic pigment added where chosen, followed by the protective topcoat.

  6. 6

    Cure and hand back

    Most garage floors take foot traffic in 24 hours and vehicles in 72 hours, and we walk the floor with you before you use it.

Concrete Stain & Epoxy in Gulf Stream: FAQ

Do I need town approval to repaint my Gulf Stream home?

Gulf Stream reviews many exterior changes, and a color change may need approval. Ask the Town of Gulf Stream what applies to your property before work is scheduled. We can supply color samples and product data sheets for your submission, and we start the exterior once your approval is in hand.

How often should a Gulf Stream exterior be repainted?

Homes with direct ocean exposure typically need exterior repainting every four to six years. Properties set back from the beach may go six to eight years. Annual soft washing to remove salt and mildew helps a coating reach the longer end of that range.

Can you refinish shutters and doors without replacing them?

Usually, yes. If the wood or composite is sound, we clean, sand and prime shutters and doors and then apply a durable finish coat. Where we find rot or damaged slats, we point it out so you can have it repaired before painting. Painting over rot only hides the problem for a short time.

How long does an epoxy garage floor last?

With normal residential use, a properly applied epoxy or polyaspartic garage floor lasts ten to twenty years. What decides where yours lands in that range is surface prep, the grade of product used, and whether the topcoat is UV-stable so it will not yellow or peel near the garage door. We diamond grind rather than acid etch for that reason.

Can you coat outdoor concrete like pool decks and patios?

Yes. For pool decks, patios and walkways in direct sun, we use UV-stable polyaspartic and acrylic systems. They resist fading and peeling and handle the heat swings that make many coatings fail on outdoor concrete in South Florida. Non-slip texture is added so the surface stays safer underfoot when it gets wet.

What is the difference between epoxy and polyaspartic?

Epoxy is very durable and builds a thick, hard film, but it can yellow in sunlight. Polyaspartic cures faster, stays UV-stable and can be applied in a wider range of temperatures. We often combine them, using an epoxy base coat for build and a polyaspartic topcoat for UV resistance and a quicker return to service.

Ready for Concrete Stain & Epoxy in Gulf Stream?

Request a free estimate or call (561) 251-6165 and we will set up a time to see your Gulf Stream property.