Stuart is the county seat of Martin County, and its homes cover a lot of ground: older houses near the historic downtown, concrete block ranch homes, condos, and waterfront properties along the St. Lucie River and its canals. Coastal Paint & Design paints and refinishes homes across that whole range. Every job starts with a close look at what the surfaces actually need, so the prep and the products fit your house instead of a one size package.
Our home base is Lake Worth, and we travel north to Martin County for interior painting, exterior painting, cabinet refinishing, roof coatings, garage floor coatings and pressure washing. You get an on site visit, a written estimate with a clear scope, and a crew that covers floors, furniture and plantings before any work begins. Call (561) 251-6165 to schedule a free estimate at your Stuart home.
Much of Stuart sits along the St. Lucie River, where the North Fork and South Fork meet before the river flows east to the Indian River Lagoon near the St. Lucie Inlet. Homes on or near that water live with constant humidity, brackish spray and a breeze that carries salt well inland. For exterior work, that means a thorough wash to strip salt film and mildew, attention to rusting fasteners and railings, and coatings made for coastal exposure.
A large share of Stuart houses are stucco over concrete block, a tough combination that still needs care in this climate. Hairline cracks let water get behind the paint, and chalky, sun faded stucco will not hold a fresh coat unless it is cleaned and primed first. We fill cracks with elastomeric patching where it suits the surface, use masonry primer where the wall calls for it, and point out any rotted trim or fascia that needs repair before we paint.
Some older homes closer to downtown have wood siding, lap boards and more detailed trim than a typical block house. These surfaces often carry many layers of earlier paint, so we scrape and sand loose areas, prime any bare wood and caulk open joints before the finish coats go on. On houses like these, patient prep is most of the job, and it is what keeps the new paint from lifting at the seams.